Monitor - Intercange Priok (2)

Name
Notes
Server
Source Type
Function
In None mode no processes are started. No capturing will occur.
In Monitor mode the capture process (zmc) will connect to the camera and stream data. It will be decoded if necessary and live viewing will be possible. No motion detection will be performed. This monitor type cannot save video.
In Modect mode the capture process (zmc) will connect to the camera and stream data. It will be decoded if necessary and live viewing will be possible. In addition the video will be analysed for motion. When motion is detected, events will be created and video will be stored. Motion data will be stored in the database for each event. Events may also be triggered externally (zmtrigger) or by linked monitors.
In Record mode the capture process (zmc) will connect to the camera and stream data. It will be decoded if necessary and live viewing will be possible. Motion detection will not be performed. Events will be created at fixed intervals and video will be stored.
In Mocord mode the capture process (zmc) will connect to the camera and stream data. It will be decoded if necessary and live viewing will be possible. In addition the video will be analysed for motion. Events will be created at fixed intervals or at start and stop of motion. Video will always be stored to disk and events will have the motion data stored in the database. Events may also be triggered externally (zmtrigger) or by linked monitors.
In Nodect mode the capture process (zmc) will connect to the camera and stream data. It will be decoded if necessary and live viewing will be possible. In addition any linked cameras will be checked for their alarm status. When linked cameras or an external trigger (zmtrigger) are alarmed, events will be created and video will be stored. No other motion detection will occur.
Analysis Enabled
When in Modect, Mocord, Nodect or RECORD mode the analysis process can be turned on/off. This setting sets the default state when the process starts up. It can then be turned on/off through external triggers zmtrigger zmu or the web ui. When not enabled no motion detection or linked monitor checking will be performed and no events will be created.
Decoding Enabled
When in Record or Nodect mode and using H264Passthrough with no jpegs being saved, we can optionally choose to not decode the H264/H265 packets. This will drastically reduce cpu use but will make live view unavailable for this monitor.
Linked Monitors (?)
Groups
Analysis FPS
Maximum FPS (?)
Alarm Maximum FPS (?)
Reference Image Blend %ge
Alarm Reference Image Blend %ge
Triggers None available
Source Path
Method (?)
Options (?)
SourceSecondPath
DecoderHWAccelName (?)
DecoderHWAccelDevice  (?)
Target colorspace
Capture Resolution (pixels)
Preserve Aspect Ratio
Orientation
Deinterlacing
ONVIF_URL
Username
Password
ONVIF_Options
Storage Area
Save JPEGs
Video Writer
OutputCodec
Encoder
OutputContainer
Optional Encoder Parameters (?)
Whether to store the audio stream when saving an event.
Timestamp Label Format
Timestamp Label X
Timestamp Label Y
Font Size
Image Buffer Size (frames) (?)
Maximum Image Buffer Size (frames) (?)
Warmup Frames
Pre Event Image Count
Post Event Image Count
Stream Replay Image Buffer
Alarm Frame Count
Estimated Ram Use
Controllable
Control Type  Edit
Control Device
Control Address
Do motion detection during PTZ motion
Auto Stop Timeout
Track Motion
Track Delay
Return Location
Return Delay
Event Prefix
Section length seconds
Minimum section length seconds
Frame Skip frames
Motion Frame Skip frames
Analysis Update Delay seconds
FPS Report Interval frames
Default Rate
Default Scale
Default Method For Viewing Events
Signal Check Points
Signal Check Colour     
Web Colour      sync
Embed EXIF data into image (?)
RTSPServer (?)
RTSPStreamName (?)
Importance (?)